A blinking red light on your TP Link extender generally means that it cannot maintain a strong and constant connection with the main router. This can be a frustrating problem, but it does not indicate any permanent damage. Normally, issues such as interference, distance, outdated settings, or improper configurations cause the red light situation. However, you need only to take a couple of quick steps to allay these issues and return to an unattended, smooth experience of WiFi coverage.
The first and most common cause is placement. The farther away your extender stands from the router, the weaker the signal tightening causes that red signal on your TP Link extender. In fact, the best way to place the extender is midway between the router and the place where you want stronger coverage. This way, it receives a strong signal to pass on.
Check for interference. Everyday things can block or weaken your WiFi signal: walls, doors, cordless phones, and microwaves. If the TP Link extender red light on wifi, try moving it to an open area away from thick walls and electronic gadgets.
Commonly, a wrong installation will lead to the occurrence of the problem. If during the setup, the incorrect WiFi that is supplied with the wrong password was selected, the extender will not be able to properly follow the router, which is the cause of the red light that is blinking continuously. To solve the problem, the setup should be done again using the TP Link Tether app or the WPS button.
Moreover, the problem may be caused by the outdated firmware. The reason why a firmware update is important is that it fixes bugs and makes the device compatible with the routers. Extender’s dashboard can help in a few minutes to get rid of the blinking problem by checking for updates.
If you've tried all the suggestions and nothing works, it may be time to reset the extender to factory default settings. Factory resetting the device clears any previous settings on the unit, allowing you to reconfigure it from the beginning. Resetting the device is simple! Just find the reset button on the bottom of the extender; it's small and requires a pin to press down. Hold the reset button until you see the extender boot, and connect it back to your router when it is done booting up.
To summarize, the TP Link extender red light blinking indicates that there is no serious trouble with the device, but it is a signal that your device needs some care. Through proper placement, lessening the interference, updating the firmware, or resetting the installation, you can use the green light to replace the red one and have a WiFi network that is continuously available in every room of your house.
Comments
0 comment